Laparoscopic Hartmann’s Procedure
KEY STEPS
1. Insertion of ports: 10-mm umbilical Hasson technique; 12-mm right iliac fossa; 5-mm right upper quadrant; 5-mm left iliac fossa (optional).
2. Patient rotated to the right and slightly Trendelenburg.
3. Laparoscopic assessment and the small bowel and omentum moved toward right upper quadrant.
4. Inferior mesenteric pedicle defined and divided, protecting the ureter and presacral autonomic nerves. The inferior mesenteric artery (IMA) may be preserved and the mesentery divided with an energy device.
5. Retroperitoneal or lateral mobilization of the descending colon mesentery.
6. Division of lateral attachments of the sigmoid and descending colon to splenic flexure.
7. Mobilization of rectosigmoid junction and choice of area for transection.
8. Transection of the upper rectum and mesorectum.
9. Exteriorization and resection of the sigmoid colon through left lower quadrant incision.
10. Formation of trephine end colostomy in the left iliac fossa.
11. Port closure.
ADDITIONAL ADVICE
1. For benign disease, our practice is not to routinely mobilize the splenic flexure, but to dissect up to this point.
2. When mobilizing the lateral attachments of the sigmoid and descending colon, elevating and drawing the descending colon medially keeps small bowel loops out of the way of the dissecting instrument and facilitates the dissection.
PATIENT POSITIONING
The patient is placed supine on the operating table on a bean bag. After induction of general anesthesia and insertion of an orogastric tube and a Foley catheter, the legs are placed in yellow fin stirrups. The arms are tucked at the patient’s side and the bean bag is aspirated. The abdomen is prepared with antiseptic solution and draped routinely (Chapter 2).
INSTRUMENT POSITIONING
The primary monitor is placed on the left side of the patient, at approximately the level of the hip. The secondary monitor is placed on the right side of the patient at the shoulder level and is primarily for the assistant during port insertion and the early phase of the operation. (Fig. 26.1). The operating nurse’s instrument table is placed between the patient’s legs. There should be sufficient space to allow the operator to move from either side of the patient to between the patient’s legs, if necessary. The primary operating surgeon stands on the right side of the patient at the level of the patient’s hip, with the assistant standing on the patient’s left. The assistant moves to the right side at the level of the patient’s shoulder once ports have been inserted. If a second assistant is available, they stay on the patient’s left side. A 0-degree camera lens is used.
UMBILICAL PORT INSERTION
This is performed using a modified Hasson approach (Chapter 3). A vertical 1 cm subumbilical incision is made. This is deepened down to the linea alba, which is then grasped on each side of the midline using Kocher clamps. A scalpel (no. 15 blade) is used to open the fascia between the Kocher clamps and Kelly forceps are used to open the peritoneum bluntly. It is important to keep this opening small (<1 cm) to minimize air leaks. Having confirmed entry into the peritoneal cavity, a purse string of 0 polyglycolic acid is sutured around the subumbilical fascial defect (umbilical port site) and a Rommel tourniquet is applied. A 10-mm reusable port is inserted through this port site allowing the abdomen to be insufflated with CO2 to a pressure of 12 mmHg.
LAPAROSCOPY AND INSERTION OF REMAINING PORTS
The camera is inserted into the abdomen and an initial laparoscopy is performed carefully evaluating the liver, small bowel, and peritoneal surfaces. A 12-mm port is inserted in the right lower quadrant approximately 2 to 3 cm medial and superior to the anterior superior iliac spine. This is carefully inserted lateral to the inferior epigastric vessels, paying attention to keep the tract of the port going as perpendicular as possible through the abdominal wall. A 5-mm port is then inserted in the right upper quadrant at least a hand’s breadth superior to the lower quadrant port. Particularly when teaching, a 5-mm left lower quadrant port is also inserted. Again all of these remaining ports are kept lateral to the epigastric vessels (Fig. 26.2).
DEFINITIVE LAPAROSCOPIC SETUP
The assistant now moves to the patient’s right side, standing at shoulder level. The patient is rotated with the left side up and right side down, to approximately 15 to 20 degrees tilt, and often as far as the table can go. This helps to move the small bowel over to the right side of the abdomen. The patient is then placed in the Trendelenburg position. This helps gravitational migration of the small bowel away from the operative field. The surgeon then inserts two atraumatic bowel clamps through the two left-sided abdominal ports. The greater omentum is reflected over the transverse colon so that it comes to lie on the stomach. If there is no space in the upper part of the abdomen, one must confirm that the orogastric tube is adequately decompressing the stomach. The small bowel is moved to the patient’s right upper quadrant, allowing visualization of the inferior mesenteric pedicle. This may necessitate the use of the assistant’s 5-mm atraumatic bowel clamp through a left lower quadrant port in order to adequately tent up the sigmoid mesentery.